Mazda 6 Forums banner
Cancel

*Urgent* Bolt Help?

909 Views 4 Replies 3 Participants Last post by  Egierda, 
D
So I'm installing my motor mount and I finally got the holes to line up however now when I stick the bolt in, it goes in, then loosens up and then gets really tight before it even gets in 3/4 of the way. Like There is no way I could tighten it all the way if it continued to get the tight.

Help?
Reply
Save
Like
1 - 3 of 5 Posts
D
It's definetly the inside. Gave up and took the mount out and the female side in the engine is fucked. The thread looks really scratched up...

This DIY is going to cost me 5x what it would to have it installed.

Fucking fantastic.

Can the engine sit overnight without a rear mount and no jack?
Reply
Save
Like
D
haha well it's nice to know I'm not the first but I can't use a longer bolt cause in the speed 6 the hole for the bolt is blind or closed or whatever you call it. Only one entrance to the hole
Reply
Save
Like
1 - 3 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Explore Our Forums
Newbie Section Mazda6 (Atenza) Exterior Modifications Picture/Videos 3.0L V6
Top