Just figure out whst thread pitch it is and re-tap the hole to clean up the threads. Done.
*Urgent* Bolt Help?
So I'm installing my motor mount and I finally got the holes to line up however now when I stick the bolt in, it goes in, then loosens up and then gets really tight before it even gets in 3/4 of the way. Like There is no way I could tighten it all the way if it continued to get the tight.
Help?
Help?
1 - 1 of 5 Posts
1 - 1 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
