Mazda 6 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
I need to run a power cable from the battery to the trunk.

Is there any commonly used grommet that I should look for.

Had a quick look yesterday but couldn't see anything that I could easily use.

There is big wiring loom coming through but that seems jam packed, also on the inside of the car the loom comes out behind the heater motor so can't actually see the other side of it when looking under the dash.

Whats the best place to run this cable through ?

I have a 2003 model 6.

Cheers
 

·
Registered
Joined
·
1,506 Posts
If your car is a manual transmission, you will have to cut a small hole in the main wiring harness gromet and jam the wire through there. Otherwise you have to drill a hole.

If you have an automatic transmission, you can use the plug used for the clutch hole.
 

·
Registered
Joined
·
56 Posts
Discussion Starter · #3 ·
If your car is a manual transmission, you will have to cut a small hole in the main wiring harness gromet and jam the wire through there. Otherwise you have to drill a hole.

If you have an automatic transmission, you can use the plug used for the clutch hole.
[/b]

Thanks Dave, will check this out at the weekend and let you all know how I get on.
 
1 - 3 of 3 Posts
Top