Mazda 6 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
886 Posts
Discussion Starter #1
As many know our O2 extensions for the headers were the wrong connector for the rear bank sensors. We are currently looking into a solution for this. Our connector manufacturer is currently working on identifying the correct connectors. Unfortuneatly they were not able to do this through emailed pictures. We had to purchase and send both rear oxygen sensors to them. Their lead time once they identify the connector is something we cannot control and do not know yet. It took almost 3 months to get the connector we are currently shipping. We are doing everything we can to make it happen faster but there is only so much we can do.

This doesn’t mean you cannot install the headers, any shop will be able to add length to the oxygen sensor wires without much difficulty. All that is required is 20 gauge wire, 3/8 wiring loom, and a soldering iron. Something any radio installation shop will have if you would like to do it yourselfers.

Please direct all questions to [email protected] , time is scarce and we do not browse the boards that often.
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
3 Participants
HYPHY6
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Top