Mazda 6 Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
471 Posts
https://secure23.bottomlinecom.net/draxas_c...47e41d65e9f9f14

what you all think about those headers and y pipe. are they a good fit, cuz they are considerably cheaper than cp-e's. i know cp-e would be the best, however i'm just looking at these to accomadate in my turbo build.

just did some searching and reading, but if anyone wants to post anyway, and give some input on these in specific, that'd be great too.
[/b]

uh oh....Draxas.
 

· Registered
Joined
·
471 Posts
Crappy relatively speaking to what? Every single header set released for the 3.0l v6 has had problems. Show me a set of headers that did not cause anyone problems at all and I will apologize.

MSDS headers were bashed by so many who never owned them that their reputation was destroyed. I did own a set, actually the first set. I am not going to repeat my comments as I have done so on multiple occasions in the past. If you have searched, you probably have located comments by myself and the other few people who have actually owned the headers.

Point is, when you get to the level of adding headers to this car, expect some hassles and inconveniences, no matter which set you order.
[/b]
My feelings concerning their product is based on Gcubed's experience, which was bad, both in terms of the product itself and the service he received after his purchase.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top