Mazda 6 Forums banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
267 Posts
Discussion Starter · #1 ·
I finally went today and got my first dyno done. All I have done to the car is a cp-e intake, other than that it completely stock. Is this about right?



Im very happy with the torque, but I was hoping for alittle more in the hp department. They said the power loss to the wheels is roughly 17-20 percent. If i say 20 percent, my flywheel hp is around 270 and torque is around 320. That doesnt sound right because they claim 274 stock and I have an intake which should add alittle at least. What do you guys think the deal is?
 

·
Registered
Joined
·
744 Posts
I dont know much about dynos but if they didnt set the fans up correctly, id think heat soak would be a huge problem since its a top mount. how long was the car running before the test. umm also i dont know if your car does but mine sometimes it just seems slower on some days, and some days it likes to go. Dyno charts for the car have been all over the place. did you get the reflash?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top