Mazda 6 Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
259 Posts
Good to read that the Fusion swap works! I've got some nasty metal particles and silvery film in my crankcase...bearing/s gone....grrrrr. After only 94000 km;(
 

·
Registered
Joined
·
259 Posts
My tech can't get my 06 Zephyr engine started. It cranks, but no spark or fuel. He says everything was put back together properly, and thinks it might be the immobilizer, but if it was that, it should start and then cut the engine, no?
Unless the main harness got damaged during the swap, I don't know what to do...it's been sitting in his shop for 2 months:(
 

·
Registered
Joined
·
259 Posts
No scan codes are thrown, my crank sensor was swapped from my old engine, no go. Haven't taken apart the old one engine, but there was a LOUD clanging coming from the bottom end, and it was missing badly with no pull...
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top