6
Hi everyone, I am running into some issues.
I have installed and spliced the dual 8” skar sub and amp kit into my 2016 Mazda6 i grand touring WITH BOSE.
Here’s what I have done:
-Positive to ANL fuse then to my amp.
-Spliced REM into 2D of a wiring diagram (it’s a 12v turn on)
-Spliced both positive (pink and gray) and negative (light green and blue) to Red (positive) and white (negative) RCA interconnects
-Ran ground from amp to side part where i could bolt onto after sanding paint off to get to metal
-Ran speaker wire from amp to sub
-Turned gain on, and turned fader up inside my radio, as well as tried to use the plug in remote to turn it on (even though it’s not needed because i’m splicing into rear pre-amp channels already)
Anything would help, as I am a little frustrated at this:/ Thank you for your time!
