Mazda 6 Forums banner
Cancel

hazard lights/rear defroster/ac all dont work...

11401 Views 14 Replies 8 Participants Last post by  Esofasto, 
H
ok, so last year I broke the faceplate for the radio, making the controls for the rear defroster and ac not work. I put a new one in today, same all around (manual climate control) and something must fried. I still don't have use of the following- rear defroster/fresh air/ac/hazard lights, and the temp doesn't show on the display. I checked all the fuses, and they all look good. I guess it could be a relay.. im just wondering what could cause all these to go out... any ideas?
Reply
Save
Like
1 - 2 of 15 Posts
ydrone
Did you take the radio console out from the dash?

One time, I broke a few pins that connect one of the boards due to brute force (didn't realize that I had to unscrew a few things). I ended up having to resolder all the connections.
Reply
Save
Like
  • Like
Reactions: 1
ydrone
Yes, take out the console again and check the ribbon cables (the ones that have like 20 pins soldered to the board).
Reply
Save
Like
  • Like
Reactions: 1
1 - 2 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Explore Our Forums
Newbie Section Mazda6 (Atenza) Exterior Modifications Picture/Videos 3.0L V6
Top