Mazda 6 Forums banner
1 - 14 of 14 Posts

· Registered
Joined
·
2,567 Posts
Discussion Starter · #1 · (Edited)
SOLD: CarbonTrix CF gauge pod A-pillars

Pillars have been sold!


========================

This is for my slightly used set of Carbontrix CF gauge pod A-pillars.

A-Pillar Gauge Pod

These CF A-pillars were from the original CarbonTrix group buy that happens a few years back. They are on the CarbonTrix website here. They are still in great condition overall. The driver-side A-pillar with the gauge pod is showing fading around one of the gauge ports which you can see in one of the photos below. Also, we put a couple rivets into that pillar due to weight of the gauges pulling it down, so it comes attached to an actual pillar trim piece. Gauge ports are 52mm. First gen 6 only.







$95 shipped.


Email is probably the best way to contact me: [email protected]. That's also my PayPal address. Post or PM with questions. Thanks!
 

· Registered
Joined
·
2,567 Posts
Discussion Starter · #4 ·
Bump.

(And I moved the boost gauge over to ebay. Tried to update the thread title, but doesn't seem to take in the thread listing?)
 

· Premium Member
Joined
·
9,498 Posts
good to see your still alive sir!!


here's a shot installed on my car to help maybe?
 

· Registered
Joined
·
2,567 Posts
Discussion Starter · #10 ·
good to see your still alive sir!!


here's a shot installed on my car to help maybe?
Thanks, it is indeed nice to be alive. And thanks for the pic!

Tempting... Wonder if these will fit on the speed? I assume they will.
I believe so, but can't guarantee. I.e., the trim attachment points may have changed? I don't know.

Jeeeeesus, those are hot! The problem is that I'll be forced to CF wrap my other pillars to match, lol.
Just keep looking straight ahead and all will be well. :D
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top