Mazda 6 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
18 Posts
THANKS a lot DennisW it was in valet mode! I never would have figured that out if you didn't say something, and probably would have paid my dealer a lot of money to tell me the unit was broken or something.[/b]

I'm having the same problem - How did you get it out of valet mode?
 

·
Registered
Joined
·
18 Posts
I thought I was having the same problem, but I just found the page in the manual about valet mode and apparently I'd see a double flash on the LED if that were my problem, but I do not.

What other obvious reasons would cause everything else to work OTHER than the remote start function itself? I went through the initial programming (start car, turn off, turn key on, wait for security to turn off, repeat with other key, hit lock, hit start) and I get the 2 chirps, a few seconds go by, and i see th dash light up for a split second and no engine start...
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top