Mazda 6 Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
So I have a set of i4 and v6 springs. I'd like to hold onto the i4s for when I decide to remove my eibachs, but do't need both sets.

From what I understand the shocks are interchangable on both models, are the springs as well? There are some red and yellow paint markings on a few of the springs, but no other markings I can see, so is there any way to tell the difference between them?

Finally does anyone need a set? I'd be happy to give them to someone, just pay for shipping.
 

·
Registered
Joined
·
2,574 Posts
there is a 200-300 lb difference up front between the i4 and the v6. the front will drop approx .5-1 inch more than the rear. ( compared to stock.)
 

·
Registered
Joined
·
2,497 Posts
In my 2.0 I have installed the 2.3 Eibach Springs. Because in USA dont make the 2.0 I had to bought the 2.3.
I suppouse will be a little rigid than 2.0 for the differences in weight
 

·
Registered
Joined
·
2,883 Posts
based on on-line part numbers:

fronts are diff for 6 vs 4, and atx vs mtx.

But rears are same for sedans. And the hatch also has common rears for 4 vs 6. Wagon rears are unique.

Any pics for posterity?
 
1 - 4 of 4 Posts
Top