Mazda 6 Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have a 04 m 6 2.0l and Im getting the code p0006 and p0001 . it says it the runner control is in the closed position. what does that mean? I replaced the two manifold runner control. solenoids and the code still comes up. can someone help me .. it runs rough and stalls..but when you floor it ,it goes like normal.. thanks
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.