Double checked the install, everything is def correct, however, the connector coming off of the turn signal bulb had one of the two metal conductors was slightly pulled out. Essentially, its just a connector, so I could cut those wires and make my own connections? Right?
Car LED Tails Problem
Installed them yesterday, everything works and looks great, EXCEPT the drivers side turning signal doesn't work at all.
Only wire I cut into, was the Green/Yellow Stripe wire to do the brake light mod. Any suggestions?
Only wire I cut into, was the Green/Yellow Stripe wire to do the brake light mod. Any suggestions?
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
