Mazda 6 Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,256 Posts
Discussion Starter #1
I installed my new IC tonight and noticed that my DH is now showing N/A for the BAT.

Perhaps I knocked a sensor wire loose or something - any thoughts?
 

·
Registered
Joined
·
676 Posts
I thought the BAT sensor was inside the IM...then again I could be wrong. Or at least near the throttle body
 

·
Registered
Joined
·
676 Posts
wooohooo i guess there is some memory after all those years of poking smot
 

·
Registered
Joined
·
3,560 Posts
Sometimes the DH loses the vehicle ID and will only show generic parameter's. You have to either restart it, or at worst, re load the firmware. Happened to me a while back.
 

·
Registered
Joined
·
1,459 Posts
Indeed. I noticed that if you hook the AP back up. The dashhawk will read again afterwards.
 
1 - 6 of 6 Posts
Top