Mazda 6 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
260 Posts
Discussion Starter #1
Is there anything I should be concerned about if I decided to run my Injen cold air intake on my 2005 Mazda 6s for a few days without my CPE MAF customizer hooked up? I am aware that I may get a check engine light, but are there any other disadvantages of running this steup?

If you didn't read the post I made below this one, the reason I am wanting to run this setup is because I have the CPE install instructions for the 2004 and earlier models. Since the install directions for the 2005 are different, I will have to wait until I get the new instructions in the mail to hook up the CPE.
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
3 Participants
Sigma
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Top