Mazda 6 Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I'm having some problems with my wife's mazda 6 with the 3.0v6.
We just bought it and were told the timing chains were bad and the PO says he replaced plugs, sensors, solenoids, everything electrical so it had to be the chains. So I buy a timing kit and some gaskets, take everything apart, chains look fine. They're good and tight and the timing marks lined up. Plugs however were not so good. One was burnt to hell and a couple others were swimming in oil. I replaced the plugs and the valve cover gaskets and plug seals.
I get the engine put back together, start the car, and it runs like garbage. I'm getting these codes:

P2092: camshaft position actuator control circuit low bank 2

p0134: O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 1)

p0140: O2 Sensor Circuit No Activity Detected (B1S2)

my code reader says those 3 are new, and p2902 and p0134 were stored.

Kinda lost here, I'm more used to old shitty bmws. I'm guessing I just need to replace those sensors?
 
1 - 1 of 1 Posts
Top