Mazda 6 Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
540 Posts
Discussion Starter #1
Last night i was looking at prices on pistons so i know how much i need when i bore the Block i found a 92 mm bore but they weren't MZR, i couldn't find anything on the 6 forums, from my understanding the factory bore is only 87.5 MM, all i could find was 88 mm is boring the block .5 mm going to make any difference? it's probably a lot and i'm just stupid but when i think .5mm i think like a peice of graphite, input is appreciated.
 

·
Registered
Joined
·
540 Posts
Discussion Starter #3
Yes. .5 is plenty. You'll need to figure out tuning. Currently for your year there are only standalone options that I'm aware of.
found out that those are if you scorch the sidewall, replacements...
found some MZR's that are 92 mm (+4.5 mm) these are the ones i'm probably gonna use
 

·
Registered
Joined
·
81 Posts
So in 2 days you went from "is this bad for the Trans?" to "Will these pistons work?".......wow
 

·
Registered
Joined
·
540 Posts
Discussion Starter #5
So in 2 days you went from "is this bad for the Trans?" to "Will these pistons work?".......wow
My question was not Will they work, i know they would work my question was Will they have any affect
 
1 - 5 of 5 Posts
Top