Mazda 6 Forums banner

2014+ Mazda6 12.6" 4 Piston Performance Big Brake Kit

22467 Views 42 Replies 16 Participants Last post by  TalonTsi90
Foremost like to thank Brian over at Fastbrakes (based in Arizona) for researching, testing for me on the parts that can fit on the Mazda 6 using stock 19" wheel, we now have another option that's easier on the wallet and in doing so they now have a kit for sale you guys can buy.. Click banner image below to go to store page.

The Kit comes with 1 piece 12.6" slotted/drilled rotors, 4 piston Wilwood Superlite calipers, performance brake pads, adapter brackets and the front braided steel brake lines. Gray calipers standard, Black or Red calipers Optional at an extra cost. Now available AP Racing calipers! Be sure to choose the caliper option you want. Requires at least 17" wheels (Spare factory wheels usually WILL NOT clear).

The kit is $865 + shipping

Also in the works, a rear offset kit, meaning an Adapter bracket to offset stock caliper to allow for a larger rotor.. Image below is an example what the kit will be like not the acutal kit, A set of oversized rotors with adapter brackets.

See less See more
  • Like
Reactions: 4
1 - 1 of 43 Posts
Says factory spare won’t fit over it. I assume that refers only to the bigger front. Is the bigger rear still smaller than the stock front rotor?

What I’m gettin at is that if you get a flat tire on a front wheel with these brakes and you don’t have a full-size spare with you, you should move one of the 19” wheels from the rear to the front and put the factory donut spare on the back. Is the stock scissor jack strong enough to lift one whole side of the car to do that wheel swapping on the roadside or will it only hold one corner of the car up?
1 - 1 of 43 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.