Mazda 6 Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I have been helping a friend on his 2006 mazda six with replacing brake pads and replacing calipers on rear the problem we r having is had front brakes before finishing the rear and after finishing the rear he has no brakes and pedal goes to the floor could it be too much air in the line or is it a bad master cylinder
 

·
Rally Racer
Joined
·
1,754 Posts
I have been helping a friend on his 2006 mazda six with replacing brake pads and replacing calipers on rear the problem we r having is had front brakes before finishing the rear and after finishing the rear he has no brakes and pedal goes to the floor could it be too much air in the line or is it a bad master cylinder
I would try bleeding first. Does not nake sense to me that a master cylinder would fail as a result of changing pads.
 
1 - 3 of 3 Posts
About this Discussion
2 Replies
3 Participants
TalonTsi90
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Top