ok,my 2004 mazda6i has a rod bearing going out.i want to put a 06 up ford fusion engine in it.so far i have heard i need to change the ignition system,intake cam or the timming cog,crank pulley,crank position sensor,camshaft sensor,oil pan timing cover,valve cover. anything else?After changing the cam do i need to adjust the valves?
2.3L engine swap guide
http://forum.mazda6club.com/2-3l-i-4/259029-engine-options-2.html
Mazda 6 and Ford Fusion 2.3L Engine Swap | Happy Wrenching
Going through the process to replace my friend's 2.3L and will provide additional images and information as I go. most of the leg work has been done for me, but making this easier to find and sticky so others can find it when they have to address the same issue.
Mazda 6 and Ford Fusion 2.3L Engine Swap | Happy Wrenching
Going through the process to replace my friend's 2.3L and will provide additional images and information as I go. most of the leg work has been done for me, but making this easier to find and sticky so others can find it when they have to address the same issue.
1 - 3 of 26 Posts
OK,It is done and running great.I put a 08 fusion engine in with 16k miles.I changed everything listed on my last post plus the fuel rail and injectors.I did not change the intake manifold because they were the same.I did use the mazda throttle body.
1 - 3 of 26 Posts
Mazda 6 Forums
Mazda6club.com is a forum dedicated to the Mazda6 / Atenza. Come and discuss reliability, performance, modifications, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
