Mazda 6 Forums banner
mazdaspeed6
1-12 of 13 Results
  1. Mazdaspeed6
    Hey, so I recently picked up a 2005 Mazdaspeed6 which was imported from Japan with a few goodies already installed; Cold air intake, Autoexe exhaust and other minor bits. I'm looking into getting the Corksport FM intercooler in the future and I'm just wondering what experiences people have had...
  2. Mazda6 (Atenza)
    Hey guys, so im in search for a short hub for my 2007 mazdaspeed 6, to put my aftermarket wheel and quick release on.. Any ideas on where to get one? Or what the spline count and diameter is for the 07 mazdaspeed 6? I've spent hours researching online and the only thing I can find is the...
  3. 1st-Gen
    I have 2006 Mazdaspeed 6, and if you didnt know, has a transmission mounted to the side. I want to plan a future engine swap, but the engine in particular has a Longitudinal based transmission. I know for a fact that it will be a pain in my ass to pull it off, and nobody has ever done this...
  4. Picture/Videos
    What’s good everyone..!? Well... everyone that still comes to this forum... Very unfortunate how activity fell off the face of the earth but I guess back when the forum was in it’s prime there were a lot less avenues to build an online community for the platform... ANYWAY! Last June I was...
  5. Newbie Section
    Hey yall, I have been looking at MazdaSpeed6 as a somewhat cheap option to get an AWD vehicle with good power. I have seen a ton of old posts about problems but I can't really find anything definitive. I am looking at one with 130lk miles currently. What common problems does the MazdaSpeed6...
  6. Cars
    Good day! Live near San Jose CA and want a rebuild project or need some spare parts? My car had a cylinder misfire issue over the summer and has been parked since. The shop I was working with recommended an engine replacement. It has approximately 167K miles on it. Let me know if you are...
  7. Speed6 Engine/Drivetrain
    So I recently bought a speed 6 with a dealer replaced motor. According to the invoice from the mid 2010s, the part number is L3M6-02-300M. Is it a gen 2 engine or is there a way to know if the vvt must've been done already or did they just replace it with another gen 1 speed engine? The engine...
  8. 1st-Gen
    Hey guys! Sooooo, without maf plugged in... engine runs okay, starts fires, hits boost haha and what not, has engine code obvs cause it’s un plugged but when I go to plug it in, cuts out and stalls & wont even start with it plugged in, I’ve swapped over with a known working one and still does...
  9. 2.3L I-4
    I took my speed6 out for a little zoom zoom action and I lost power steering and it wouldn’t let me shift gears got it home checked the power steering pump which was fine and no at idle it makes a loud rattle noise at 1500-2000 rpm and when I drive it up to second gear haven’t got it above...
  10. Mazdaspeed6
    Hello everyone I am the new guy and I couldn’t find anything on if this would be a bad idea but I’m looking at purchasing my first speed 6 and I recently came across a speed 6 for 3k obo but it burns a little oil the engine has 147k miles and all the required maintenance and oil changes done...
  11. Mazdaspeed6
    Hi guys, This is my first time ever using a Forum before so please excuse me if I do anything wrong. I have a 2006 MazdaSpeed 6 that is having issues. I bought this car on Saturday, November 16, 2019, The goal of this car was to be my daily driver for university. I drove six hours to get this...
  12. Cars
    Hey guys, I'm looking to sell my 2007 Mazdaspeed 6 since I'm now looking to get another car. The car has treated me well, but does require a bit of love. Power steering pump needs a new line, rear passenger window motor needs replacing, and has been consuming some oil, so likely needs a new...
1-12 of 13 Results
Top