Mazda 6 Forums banner
mazda6
1-20 of 34 Results
  1. 2nd-Gen
    Ok long story short my 10 mazda 6 4 cylinder basically starts to stall after reaching normal operating temperature. I've changed the MAP sensor the fuel pump and the catalytic converter first of the manifold and I've cleaned my EGR valve and Throttle body. Car will drive fine for about 15...
  2. Electrical / HVAC
    I have 2017 Mazda6 Sport Manual. For about 2 years everything was fine. Then I started noticing this behavior - with all HVAC controls in off position, you start the car and soon after that or even during drive, the blower would suddenly start blowing for a second or two, then stops. Later, I...
  3. Engine / Suspension / Drivetrain
    Can someone please help clarify if there is more than one belt tensioner? They told me I needed the belt tensioner replaced because it was leaking. I was advised this would cost me about $450.00. I reviewed my warranty Manual and according to the power train warranty it shows that part is...
  4. 1st-Gen
    So my older brother just gave me his old car so I can fix it up and have it as my own. I'm really new to fixing up cars and I've only ever taken a small engines class so I know somewhat about oil change, sparkplug, pistons but not really actually cars. The car has been sitting still for like 4...
  5. No image available
  6. 3rd-Gen
    Hi guys, I need help to adjust my headlights. After a minor crash (not my fault) I took the car to service Geiko recommended to replace the front bumper, left headlight and left fender panel. Can't say they did a good job, as a result, dead battery, new dent in the hood and misaligned...
  7. Mazda 6 3rd Generation (2013-Present)
    Hey everyone! I have a 2017 Mazda6 Grand Touring, and was wondering if the Front Camera that comes as a part of the car on the windshield can be used to record video like a dashcam for insurance? If not by default is there a way to mod it to do so? Same with the rear camera, its a shame to have...
  8. Mazda 6 2nd Generation (2008-2013)
    I have done everything I possible could to try to fix what seems to be a fairly simple problem. It only happens when the car is warmed up although when it’s still cold there’s a faint fan belt sound but turns into the spark knock sound when fully warmed up. It also only happens when under load...
  9. Exterior Modifications
    HI, anyone from NZ here that could tell me if it's possible to do interior and exterior modifications from a shop in the south island, please?
  10. Mazda 6 3rd Generation (2013-Present)
    Hello, I have a problem. So my Mazda dealership here in Iceland called in our Mazda 6 2013 because of some problems. They changed some leavers and restarted or fixed the PCM computer. The problem is that when we got the car 2 days later something was wrong with the car. First of all my wife...
  11. Mazda 6 3rd Generation (2013-Present)
    Hi, I'd like to install apple Carplay for my Mazda6 2014 GT, located in Canada. When I contacted a Mazda dealer, they said it could be installed for less than $500. So, is it possible to install it in my car? Looking at the install link, I thought my screen wasn't that way, so Retrokit didn't...
  12. Models / Trim
    this mazda 6 in my shop has the rear right seatbelt stuck whilst the seat is pulled down have no clue what to do any help
  13. 1st-Gen
    I just bought a 2004 6 3.0 with 134k miles on it. Sometimes during cold start it makes an odd rattling noise for a second, and also a noise at 1-2k revs sometimes when warm. The car is throwing the p0345 (cam position sensor circuit ) and p0012 (intake cam bank 1 over - retarded). The car runs...
  14. Newbie Section
    Seems like a simple enough thing for me to figure out and know but I would like to seek knowledge from those wiser than I. After not having the AC on for many months, it's finally starting to get hot enough in the afternoon to turn in it on and I did so the other day without any issues, sans the...
  15. 2.5L I-4
    Hi all, I’m having issues with my Mazda6 GS-L 2020 2.5l with CD vibrating terribly when going into two cylinder mode? It's the worst while going between 80kmh and 100 kmh Has anyone had a resolution to this issue from Mazda ? Please help!! I have around 2000km on the car and just starting to...
  16. 3rd-Gen
    I recently tried doing my own brake job on my Mazda6 2015 sport. Once I took off the caliper and the pad, the piston was pushed out like it is supposed to be. So I put the brake pad and a clamp and started to push it down. While trying this and in multiple ways, the piston still never came down...
  17. Mazda6 (Atenza)
    my Mazda 6 04 gearbox has been making a slamming sort of noise, haven't been able to yet determine if it's to do with the clutch being engaged or the actual changing of the gear itself. So far i've only tried taking off in first and stalled every time, and every time the gearbox makes a loud...
  18. Picture/Videos
    Hi. Let me represent you my new car. It's Mazda 6 2.2 SkyActive-d 150ps, 2014. Soul red color, with 96000km My first investment in car will be (maybe i said maybe) mudflaps, cloth carpet's for "summer mode", and reupholster the steering wheel... Because, i don't know if anyone can see (i...
  19. Mazda6 (Atenza)
    Mazda 6 2006 manual transmission Symptoms Delayed Rough idle (rpms go up and down constantly after a few seconds), engine hesitation and hard buckling/jerking in second gear, burning rich. Most recently, the gas pump nozzle was shutting off during filling (have not been back to fill...
  20. 3rd-Gen
    Ok, this might sound like a fantasy that makes no sense, but my knowledge of how the skyactive engines work (maybe even engines overall) is a bit limited, so I thought I would ask the experts here the question. So, tuning skyactive engines is considered 'stupid' and a waste of time, as they...
1-20 of 34 Results
Top